31 products · PKR prices · Updated October 2026
Heaters & Heating ElementsPrice in Pakistan
Shop genuine heaters & heating elements at EU Enterprise, Lahore. Prices range from Rs 300 to Rs 32,000. Order online or on WhatsApp with Cash on Delivery across Pakistan.
Showing 1–12 of 31 products · Page 1 of 3
Three phase and Single Phase U-Shaped Heater industrial heater - 18kw
Rs 32,000
10 in stock
Three phase and Single Phase U-Shaped Heater industrial heater - 9kw
Rs 9,500
10 in stock
Three phase and Single Phase U-Shaped Heater industrial heater - 6kw
Rs 7,500
10 in stock
Three phase and Single Phase U-Shaped Heater industrial heater - 4.5kw
Rs 7,500
10 in stock
Three phase and Single Phase U-Shaped Heater industrial heater - 3kw
Rs 5,500
10 in stock
Mica Band Heater for Injection Molding Machine - 36x40
Rs 1,100
10 in stock
Mica Band Heater for Injection Molding Machine - 30x30
Rs 900
10 in stock
Mica Band Heater for Injection Molding Machine - 30x38
Rs 1,200
10 in stock
Mica Band Heater for Injection Molding Machine - 50x50
Rs 1,200
10 in stock
Mica Band Heater for Injection Molding Machine - 55x33
Rs 1,200
10 in stock
Mica Band Heater for Injection Molding Machine - 40x60
Rs 1,200
10 in stock
Mica Band Heater for Injection Molding Machine - 40x40
Rs 1,200
10 in stock
Heaters & Heating Elements buying guides
Heaters & Heating Elements Price List in Pakistan (October 2026)
Prices in PKR · Updated October 2026
About Heaters & Heating Elements
Industrial heating elements turn electricity into heat for moulds, tanks, ovens, pipes and water heating. This range covers cartridge heaters, band heaters, immersion and U-shaped heating elements, geyser elements, and room or process heaters.
Heater life depends on a good fit to the surface it heats and on a power density that suits the material.
How to choose
- Power and voltage: the wattage and the supply (230 V single-phase or 400 V three-phase). Size the power from the heat to be delivered and the time allowed to heat up.
- Dimensions: a cartridge heater must be a close fit in its bore, and a band heater must match the diameter and width of the barrel or nozzle.
- Watt density: a loose-fitting heater overheats and fails. Choose a watt density that suits the material being heated, lower for liquids and plastics that degrade.
- Sheath material: copper for clean water, stainless steel for general use, and Incoloy or titanium for corrosive liquids. Check the maximum temperature.
- Control: pair the heater with a temperature controller, a thermocouple or Pt100 sensor and a contactor or SSR, and add an over-temperature cut-out where safety requires it.
Heaters & Heating Elements: frequently asked questions
Why do heating elements burn out early?
Common causes are a loose fit, scale or sludge on immersion elements, running dry, and a power density that is too high for the medium. Keep the element fully covered, descale it regularly and fit a temperature limiter.
What is the difference between a cartridge heater and a band heater?
A cartridge heater is a rod that is inserted into a drilled hole in a block or mould. A band heater clamps around the outside of a barrel, nozzle or pipe.
Can I connect a heater directly to a temperature controller?
Only if the controller’s output is rated for the heater current. For anything above a few amps use a contactor or solid-state relay driven by the controller.